100% Pass Cisco 642-887 Exam – Latest 642-887 Practice Exam Dumps

By | February 8, 2018

Your success in Cisco Certified Network Professional Service Provider 642-887 Certification exam ensures your professional strength in order to be more successful in future. But you should know the pattern of Cisco Implementing Cisco Service Provider Next-Generation Core Network Services exam to perform well in it. PracticeDumpsGuru provides you latest 642-887 practice exam Questions. The Cisco 642-887 practice exam dumps material consists of two formates, practice test software and pdf files. Practice test software has a user-friendly interface, which helps you to test your preparation and point out your weak areas. Pdf files consists of latest Cisco 642-887 exam questions.

♥♥ 2018 NEW RECOMMEND 642-887 Exam Questions ♥♥

642-887 exam questions, 642-887 PDF dumps; 642-887 exam dumps:: https://www.dumpsschool.com/642-887-exam-dumps.html (130 Q&A) (New Questions Are 100% Available! Also Free Practice Test Software!)

Latest and Most Accurate Cisco 642-887 Dumps Exam Questions and Answers:

Question: 21

Referring to the Cisco IOS XR show command output exhibit, what are three possible reasons that the GigabitEthernet0/1/0/10 LDP IGP sync status is not ready? (Choose three.)

A. GigabitEthernet0/1/0/10 is not configured to run LDP.
B. Graceful restart is not configured on the peer.
C. The LDP neighbor on GigabitEthernet0/1/0/10 is not up.
D. The OSPF neighbor on GigabitEthernet0/1/0/10 is not up.
E. LDP is up on GigabitEthernet0/1/0/10, but no label bindings have been received from the peer.
F. GigabitEthernet0/1/0/10 is a member link of Bundle-Ether9000.

Answer: C, D, E

Question: 22

Refer to the exhibit. XR2 needs to have LDP configured with PE1. Which configuration achieves this goal?

A. interface giga 0/0
Mpls ip
B. router ospf 1
mpls ldp auto config area 0
C. router ospf 1
area 0 mpls ldp auto config
D. interface giga 0/1
mpls ldp

Answer: C

Question: 23

DS-TE implementations on Cisco routers support which bandwidth pool(s) and class type(s)? (Choose two.)

A. global pool only
B. subpool only
C. global pool and subpool
D. class-type 0 only
E. class-type 1 only
F. class-type 0 and class-type 1

Answer: C, F

Differential Service Tunnels
Differential Service Traffic Engineering (TE) is an extension of the regular MPLS Traffic Engineering (MPLSTE) feature. Regular TE does not provide bandwidth guarantees to different traffic classes. A single bandwidth pool (global pool) is used in regular TE that is shared by all traffic. In order to support various class of service (CoS), the ability to provide multiple bandwidth pools is required. These bandwidth pools then can be treated differently based on the requirement for the traffic class using that pool.
In RSVP global and subpools reservable bandwidths are configured on a per interface basis to accommodate TE tunnels on the node. Available bandwidth from all configured bandwidth pools is advertised using Interior Gateway Protocol (IGP). RSVP is used to signal the TE tunnel with appropriate bandwidth pool requirements.

Question: 24

Which field in the MPLS shim header is used to support different QoS markings?

A. IP precedence
D. ToS
E. S
F. Label

Answer: C

MPLS EXP Marking
The three MPLS EXP (experimental) bits in the shim header of an input or output MPLS packet header may be set or changed by a user configured value

Question: 25

On a Cisco IOS XR router, which mechanism protects the router resources by filtering and policing the packets flows that are destined to the router that is based on defined flow-type rates?

C. Committed Access Rate
D. Control Plane Policing
E. Management Plane Protection
F. NetFlow

Answer: B

Local Packet Transport Services (LPTS) maintains tables describing all packet flows destined for the secure domain router (SDR), making sure that packets are delivered to their intended destinations.
The Low Latency Queueing feature brings strict priority queueing to Class-Based Weighted Fair Queueing (CBWFQ).

Question: 26

When configuring LLQ (strict priority queue) on a traffic class using the Cisco IOS XR priority command on a Cisco ASR9K router, which additional QoS command is required for this traffic class?

A. shape
B. police
C. random-detect
D. bandwidth

Answer: B

The Low Latency Queueing feature brings strict priority queueing to Class-Based Weighted Fair Queueing (CBWFQ).

New Updated 642-887 Exam Questions 642-887 PDF dumps 642-887 practice exam dumps: https://www.dumpsschool.com/642-887-exam-dumps.html